same name wrote:Classis Sparksy, where did you get the actual switch from.
ih8ubarney wrote:my mate just wired my lightforce rok 20's into the reverse loom, i think for the trailer plug. and i found a few well positioned holes in the under side of the bumper for the lights to bolt into.... but the bumper didnt need to come apart to do that.
the plasitc does unclip but its a bit of a pain.... i pulled mine apart to powder coat the chrome bumper pieces black.... think i only damaged 1 clip, there are plenty of clips so it wasn't an issue
will try and get a pic over the weekend
BReidy94 wrote:ih8ubarney wrote:my mate just wired my lightforce rok 20's into the reverse loom, i think for the trailer plug. and i found a few well positioned holes in the under side of the bumper for the lights to bolt into.... but the bumper didnt need to come apart to do that.
the plasitc does unclip but its a bit of a pain.... i pulled mine apart to powder coat the chrome bumper pieces black.... think i only damaged 1 clip, there are plenty of clips so it wasn't an issue
will try and get a pic over the weekend
Which colour wire on the trailer loom?
BReidy94 wrote:Hi All,
I'm in the process of adding some backwards light. The intention is to mount a small led light bar under the rear step next to the tow ball.
Two questions;
- does the plastic around the back step just unclip or is it a Toyota special and require a left handed screw driver and lots of curse words
- when wiring in the light, whats the best way to supply power only when the reversing lights are active? I would imagine a simple splice is not advisable. New wire and relay from the engine bay or is there a simple fix?
Cheers All!
BReidy94 wrote:Does anyone know what amps the trailer loom supports?
It's a genuine one, dealer installed.
Users browsing this forum: No registered users and 3 guests